The reducer is a power transmission mechanism that uses the speed converter of the gear to reduce the number of revolutions of the motor to the desired number of revolutions and obtain a larger torque. The main functions of the reducer are: 1) Reduce the speed and increase the output torque at the same time. The torque output ratio is multiplied by the motor output and the reduction ratio, but be careful not to exceed the rated torque of the reducer. 2) Decelerationreduces the inertia of the load at the same time, and the reduction of inertia is the square of the reduction ratio. You can look at the general motor has an inertia value. The following is how to change the oil of the reducer provided by Xinda Motor. What are the methods of oil change for reducer?
In the daily maintenance of the reducer, it seems very simple to replace the lubricating oil, but please pay attention when changing the oil:
1. It is forbidden to mix different lubricating oils with each other.
2. The positions of the oil level plug, oil drain plug and breather are determined by the installation position.
3. When changing the oil at the operating temperature, it is difficult to drain the oil due to the increase in viscosity of the oil after cooling.
Review the following steps when changing oil:
1. Please be sure to cut off the power first, and wait for the reducer to change the oil when the temperature of the reducer is warm.
2. Put an oil pan under the oil drain plug.
3. Open the oil level plug, breather and oil drain plug.
4. Remove all the oil.
5. Install the oil drain plug.
6. Inject new oil of the same grade.
7. The amount of oil should be consistent with the installation position.
8. Check the oil level at the oil level plug.
9. Tighten the oil level plug and breather.
Post time: Feb-07-2023